Single strand sprocket with one group of teeth around the circumference for applications in which a single chain can support the torque and load
Pitch of 3/4 inch for size 60 chains
Sprocket bore and hub with QD fittings for inserting and locking bushings into place
Type B sprocket with a hub projection using one part to accommodate numerous kinds of bushings to help prevent sprocket from slipping on the shaft
Sprocket teeth assist in preventing slipping and binding in order to avoid power loss in assemblies
This Tsubaki roller chain sprocket includes a 3/4-inch pitch, fits size 60 chains, and is single strand with one group of teeth around its circumference for use with single strand chains. It is a Type B sprocket with a hub projection encircling the bore on one side, and both the hub and bore have Quick-Disconnect (QD) fittings for inserting and locking into place different QD bushings based on the diameter of the shaft. The teeth of the sprocket assist in preventing slipping and binding to avoid power reduction in assemblies. It satisfies International Firm for Standardization (ISO) 9001 for quality assurance. This one strand roller chain sprocket is certainly suitable for use in a broad range of applications including light to moderate loads and ongoing, high-cycle procedures, including vehicle transmission systems, building and agricultural apparatus, conveyors, and factory production and assembly lines, among others.
A roller chain sprocket is a thin wheel with deep, uniformly spaced teeth ringing its circumference. The distance from the peak of 1 tooth to another is called the pitch, and is commonly measured in 1/8-inch increments. The sprocket transfers power and motion by a roller chain that’s threaded over one’s teeth of the sprocket. The alignment of the chain with the sprocket’s pitch helps prevent the chain from slipping so that no power is lost. In the center of the sprocket is the bore (hole) for sliding the sprocket onto a shaft, and a bushing or bearing is often suited to the sprocket’s hub to custom made-suit the sprocket onto a shaft to hold it firmly set up. A hub can be a protruding, elevated lip encircling the bore of the sprocket. Sprockets with hubs on both sides are Type C, sprockets with hubs on one side are Type B, and sprockets without hubs are Type A sprockets. For applications requiring sprockets to end up being swapped onto shafts of different diameters, a sprocket with a bore huge enough to fit all shafts can be used, with the gap between your bore and shaft closed with a bushing or bearing. Roller chain sprockets are used in a broad range of applications where in fact the drive power of an engine needs to be transferred into motion, such as in motor vehicles, conveyors, escalators, agricultural, forestry and mining equipment, aeronautics, robotics and space exploration, amongst others.
U.S. Tsubaki Power Tranny manufactures a variety of chains, sprockets, and additional power transmission elements that meet International Organization for Standardization (ISO) specifications for quality assurance. The company, founded in 1917, can be headquartered in Wheeling, IL.