Power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
General Description
This power unit is intended solely for the smaller lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has been extensively applied while in the field of logistic units such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled by the solenoid valve with the pace managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is designed exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as velocity managed through the adjustable needle valve. Once the lift rises to a large positoin, however the electrical power supply is lower, the reducing motion is managed through the guide override function.
Energy UNITS FOR LIFT TABLE 3
General Description
This electrical power unit is made exclusively for that substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve along with the pace controlled by a pressure compensated flow control valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is designed solely for that massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the power supply is lower, the decreasing motion is controlled from the manual override function.
Specific Notes
one. This energy unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned ahead of set up of the energy unit.
three. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and free of impurities.N46 hydraulic oil is recommended.
four. Oil modifying is needed soon after the preliminary 100 operation hrs,afterwards as soon as every 3000 hrs.
5. The energy unit shown is designed to be mounted vertically.