rotary cutter gearbox
rotary cutter gearbox
RC-20 Collection
Technical specs
Torque: one,750 – 3,267 lb.-in.
198 – 369 Nm.
Ratios: 1:2.5, 1:2.eighty three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 16 oz. (.forty seven L)
Weight: 34 lbs. (fifteen.4 kg)
Programs
Finishing Mowers Rotary Cutters
Rotary Slashers Toppers
RC-27 Series
RC-thirty Series
Technical specs
Torque: 2,800 – 4,667 lb.-in.
316 – 527 Nm.
Ratios: 1:one.47, 1:1.seventy one, 1:1.93
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 23 oz. (.sixty eight L)
Excess weight: fifty one lbs. (23.1 kg)
Programs
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-51 Series
Specifications
Torque: two,800 – 4,667 lb.-in.
316 – 527 Nm.
Ratios: 1:1.forty seven, 1:one.71, one:one.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Tapered Roller/ Deep Groove Ball
Oil Cap: 27 oz. (.80 L)
Weight: 56 lbs. (twenty five.four kg)
Applications
Rotary Cutters Rotary 
Slashers
Gears: Available with either straight bevel or spiral bevel gearing.
Electrical power: Hp & Torque based on AGMA formulation for ongoing duty plus a provider or load class element.
Shafting: Different dimensional, metallurgical, and warmth-handle choices available.
Bearings: Geardrives accessible with a variety of bearing life options.
Lubrication: Drives obtainable with different lubes dependent on working attributes
Alternative Rotary Cutter gearbox, 40hp rated, one-three/8″-six spline input shaft, one.fifty seven” X 12 tapered spline output shaft and 1:one.47 velocity up ratio. These gearboxes have a square housing configuration and are similar in mounting and ratio to the round configuration gearboxes. These are original equipment gearboxes on the IM402, IM502 and IM602 collection rotary cutters which featured slip clutch PTO shafts. This gearbox will not fit the IM400, IM500 and IM60 designs as they have a smooth enter shaft! If your gearbox has a twelve spline output shaft and a one-three/eight” – 6 spline enter shaft this gearbox will perform. Bolt pattern is four-three/four” on centre gap to gap and 6-three/4″ center to centre of bolt gap on diagonal. The mounting holes form a sq. bolt sample.
rotary cutter gearbox
Should find out about rotary cutter gearbox? Find out here.