Steady Sleeve Series
Very simple and reasonably priced all steel form of gear coupling constructed that has a single sleeve and 2 hubs
Comparatively easy set up
Precision lower 20° stress angle gear teeth with minimal backlash
Most normal configurations can be found as stock products
Angular misalignment of 1/2° per gear mesh (flex-plane)
Sizes 7/8 by means of twelve, to accommodate bore sizes as much as and which includes 12.50 inches
Interference match (normal) and Clearance match on bores are available
Load Capacities vary from 2,500 in-lbs up to two,520,000 in-lbs
Types for applications requiring horizontal and vertical orientation, full-flex, flex-rigid, mill-motor, disengagement, sliding hubs, Shear Pin, floating shaft, and spacers
Patented and tested BUNA N seal style and design with reinforced washers bonded on the inside edges which positively retain lubricant and seal the interior from outdoors contaminants
Reinforced rubber seals with snap rings to hold in lubricant
Two snap rings manufactured from hardened spring steel which securely hold the coupling with each other, are effortless to install or eliminate, nonetheless withstand 100,000 lbs of end thrust
Inch and Metric bore sizes readily available
Flanged Sleeve Series
Patented tooth type for prolonged coupling existence
Precision lower 20° stress angle gear teeth with minimal backlash
All steel sleeves and hubs (stainless steel readily available)
Designs for applications requiring horizontal and vertical orientation
Most conventional configurations are available as stock items
Angular misalignment of 1-1/2° per gear mesh (flex-plane) up to size five.five, 3/4° for sizes 6 and above
Coupling sizes accessible by size thirty to accommodate bore sizes up to and together with 44 inches
Interference match (normal) and Clearance match on bores are available
Load capacities vary from seven,600 in-lbs as much as 47,269,000 in-lbs
Exposed bolts typical on all sizes, shrouded out there by request as much as size six
Regular bolts provided are handled for being corrosion resistant
Flanged sleeve couplings are interchangeable with marketplace specifications
Piloted gear match for higher speeds and significantly less vibration
Labyrinth all steel seal style in FL series
Inch and Metric bore sizes available
Conventional Forms and Sizes
Sier-Bath couplings are stocked in an assortment of configurations which include C and F conventional hubs and sleeves, Mill Motor hubs, Vertical type, Floating Shaft, and Spacer designs. ’s superb engineering personnel make it probable to assistance several supplemental coupling kinds this kind of since the Brakedrum sort, Sliding Hub form, Shear Pin variety, Jordan variety, and custom lengths for non conventional shaft separations. Supplemental dimension ranges and designs to meet unusual application needs could also be manufactured by to meet marketplace demands. Material can vary from typical steel to alloy steel and in many cases stainless steel. The outstanding simplicity in the coupling design and style make this all doable.
Misalignment and End-Float Capability
The essential principle of Sier-Bath C and F kind couplings is much like that of other typical flexible gear couplings. When it truly is desirable to align shafts as accurately as you possibly can, the function of any flexible coupling is to absorb probable angular, parallel, and axial (end-float) misalignment. Sier-Bath couplings utilize a one of a kind gear tooth geometry designed exclusively to resolve troubles with shaft misalignment and accommodate from 1/2° to 1-1/2° per gear mesh or flex plane. The hub teeth are thoroughly crowned to supply for a larger contact area and reduced stresses underneath misaligned problems. The crowned tooth style also eliminates the vast majority of the end loading that happens on straight Continuous%20Sleeve%20Seriesgear teeth underneath misalignment.