SMR Gearbox Set up
Satisfactory overall performance relies on right installation. lubrication and maintenance. for that reason it is vital that the directions from Installation%204the installation and upkeep leaflet. supplied with each gearbox. are followed meticulously. several of the important elements of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as near on the reducer achievable, and mount reducer on driven shaft as near to bearing as practical. failure to perform this can induce extra loads during the input shaft bearings and output bearings and could induce their premature failure.
two. Install motor and wedge belt drive with the belt pull at around 90° for the center line concerning driven and input shafts. this will likely permit tensioning on the wedge belt drive with the torque arm which really should preferably be in stress. if output hub runs anti-clockwise. torque arm really should be positioned the proper.
3. lnstall torque-arm fulcrum on a rigid help in order that the torque-arm is going to be at about suitable angles for the center line through the driven shaft as well as the torque arm case bolt. be sure there’s enough consider up from the turnbuckle for belt stress adjustment.
Keep near.
Bell drive may be found in any easy postion. in case the torque arm should be to be applied to tighten the belts, the drive must be at about tight angle to your line between the input and output shafts.
Bell drive can be positioned for the correct if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that proven within the illustration.
Torque arm and belt consider up.
Torque arm could be mounted for the ideal if wanted.